Table of Contents
Gas Geyser Not Heating â Common Causes
1. Pilot Light is Out
The pilot light is a small flame that ignites the main burner. If it goes out (due to wind, gas pressure drop, or thermocouple failure), the geyser won't heat. Check the pilot light window â if dark, it has gone out.
You can relight it following the manufacturer instructions. If it won't stay lit, the thermocouple is faulty and needs professional replacement.
2. Gas Supply Issue
Check if other gas appliances (stove, room heater) are working. If not, the issue is with the gas supply â SNGPL load shedding or a closed main valve.
3. Faulty Gas Valve
The gas valve controls flow to the burner. A faulty valve means gas won't reach the burner. This requires professional replacement.
4. Thermostat Set Too Low
Check the temperature dial. If set very low, water may warm but not feel hot enough. Turn it up and wait 20â30 minutes.
Electric Geyser Not Working â Causes
1. Tripped Circuit Breaker
Electric geysers draw significant power. Check your distribution board â if the geyser breaker has tripped, reset it. If it trips again immediately, there is an electrical fault.
2. Burnt Heating Element
The heating element heats the water. In Rawalpindi and Islamabad, high mineral content in water causes scale buildup that burns out elements. This is the most common fault in electric geysers.
3. Thermostat Failure
A faulty thermostat means the element either never switches on or never switches off, causing overheating and the safety cut-off to trip.
Geyser Leaking Water
- From pressure relief valve (PRV): Normal to occasionally drip, but constant dripping means pressure is too high or PRV is faulty.
- From inlet/outlet connections: Loose or corroded fittings. Usually fixable with tightening or new fittings.
- From the tank body: Corrosion has eaten through the tank lining. The tank needs replacement â no permanent repair for a corroded tank body.
Safe DIY Checks
- Check if gas supply is on â test another appliance
- Check the electric breaker for the geyser â is it tripped?
- Check the temperature dial â is it set high enough?
- Listen for the burner clicking on when you open a hot tap
- Check if the pilot light is visible through the sight window